Please note that JavaScript and style sheet are used in this website,
Due to unadaptability of the style sheet with the browser used in your computer, pages may not look as original.
Even in such a case, however, the contents can be used safely.

Evaluation Request

PIStream

Genissnx

CyberWorkBench

Difference From 3D EMC Solver

bucket

EMIStream is NOT a 3D simulator.
This tool gives you 70% of the solution,and it works!
EMIStream is the best solution for real world
PCB design.

For example….
If there was a bucket with a lot of holes in it and water was spilling out. To stop the water from leaking out, you would need to find out the location of all the holes and patch up these holes.

In the case of EMIStream, it can find out the approximate locations and tell you how to patch them in just few seconds.
Although the patch size is not exactly the same as the hole size, it is a little bigger than the hole size, so you can stop water from leaking.

The simulator calculates in-depth holes size, amount of water leaking, and hole location. To calculate these items, you would need an expert and still correcting this information takes many long hours.

EMIStream’s threshold is set with a stricter guideline than the normal EMC standard, and you can estimate possible EMI issues quickly.
By executing fundamental countermeasure and solving EMI issues at the schematic/layout stage, you can improve efficiency, significantly decrease time and cost spent on the evaluation process, and enable a more rapid time-to-market.

This is the idea of EMIStream.

Share: